Filters
Close

Battery Chargers & Jump Leads

View as
Sort by
Display per page

1 Hour Charger + 4 x AA 2300 mAh Batteries

1 Hour Charger + 4 x AA 2300 mAh Batteries
£34.84 excl VAT

Battery Charger 20-65ah 4 Amp

This Faithfull compact 4Ah / 48 Watt maximum rated Battery Charger is designed for use with 12V lead acid batteries, with a capacity of between 20 – 65Ah.

An easy to read LED readout system indicates the battery's state of charge, making it simple to see when the battery is fully charged and ready for use. Also suitable for use as a battery tester.

Not suitable for use with AGM or EFB type batteries used in vehicles with start/stop technology

The charger has many safety features including:
Thermal overload protection.
Short circuit protection.
Over current protection.
Double insulation.
CE approval.

Specifications:
Output: 4Ah / 48 Watt.
For battery type: 12 Volt lead acid 20Ah - 65Ah.
Power supply voltage: AC 220~240V 50Hz.
Output voltage: DC 12V.
Battery capacity: 20Ah - 65Ah.

£23.77 excl VAT

Battery Charger 9-112ah 8 Amp 240 Volt

This Faithfull Battery Charger is a versatile 8Amp 140 Watt maximum rated battery charger, designed for use with both 6V and 12V lead acid batteries, with a capacity of between 9 - 112Ah.

The charger features a voltage selection switch that can be set to charge either 6 or 12 volt batteries, along with an ampere switch to select the desired rate of charge (fast or slow). The analogue dial provides an accurate readout of the batery's state of charge and may also be used as a battery tester when not connected to the mains.

Not suitable for use with AGM or EFB type batteries used in vehicles with start/stop technology

The charger has many safety features including:
Thermal overload protection.
Short circuit protection.
Over current protection.
Double insulation.
CE approval.

Specifications:
Power supply voltage: AC 220~240V 50Hz.
Output voltage: DC 6V/12V.
Charging current:
High Rate 5.6 Adc equal to 8 Amps RMS.
Low Rate 2.8 Adc equal to 4 Amps RMS.
Battery capacity: 9Ah - 112Ah.

£30.86 excl VAT

BBCE12-3 Fully Automatic Battery Charger 3A 12V

The Bahco BBCE12-3 Fully Automatic Battery Charger uses microprocessor controlled technology 'Connect and Forget' with multi-charge charging for added precision, safety and battery life. Reverse polarity protection helps protect battery and charger from damage.

Designed for all types of lead-acid batteries like AGM, Cal/Cal, Gel, SLI, VRLA, EFB including Start&Stop a well as Lithium LiFeP04. Ideal for charging: motorcycles, quads, lawn mowers, small boats, cars etc.

Battery Charging Range: 12V: 6-58Ah.

£93.18 excl VAT

De-ionised Water 1 Litre

Size. 1 Litre

£0.55 excl VAT

De-ionised Water 25 Litre

Size: 25 Litres

£9.61 excl VAT

De-ionised Water 5 Litres

Size: 5 Litre

£2.06 excl VAT

Jump Leads - 2.5m - 200amp

To start a car with a flat battery you need the S Style SSJL200, a set of good quality heavy-duty cables with beefy clamps at each end, and a friend is also a good help! Your friend must have a car with a battery in good condition, as this will aid in the success on starting your flat battery.

Simply position another car near yours so that the batteries are close, but do not let the vehicles touch. Connect one end of the red jump lead to the positive (+) terminal of the boosting battery (Do not let the other end of the red lead touch any vehicle metal components) and connect the other end of the red lead to the positive (+) terminal of the flat battery.

Then connect one end of the black jump lead to the negative (-) terminal of the boosting battery and connect the other end of the black lead to a bolt or metal bracket, well away from the battery, on the engine block of the vehicle to be started is a good source.

Ensure that the jump leads cannot come into contact with any moving parts of either engine. Start the engine of the boosting vehicle and run it at a fast idle speed for a few minuets. Now turn the ignition to start the engine of your vehicle, the leads will pull power from the boosting battery to help your battery back to life. Check that your vehicle is running properly then carefully disconnect the leads, and your on your way.

200 Amp.
2.5m length.
Jump lead with 10mm insulation.
Supplied in poly bag with euro slot.

£7.53 excl VAT

Jump Leads - 3.0m - 600amp

To start a car with a flat battery you need the S Style SSJL600, a set of good quality heavy-duty cables with beefy clamps at each end, and a friend is also a good help! Your friend must have a car with a battery in good condition, this will aid in the success on starting your flat battery.

Simply position another car near yours so that the batteries are close, but do not let the vehicles touch. Connect one end of the SSJL600 red jump lead to the positive (+) terminal of the boosting battery (Do not let the other end of the red lead touch any vehicle metal components) and connect the other end of the red lead to the positive (+) terminal of the flat battery.

Then connect one end of the SSJL600 black jump lead to the negative (-) terminal of the boosting battery and connect the other end of the black lead to a bolt or metal bracket, well away from the battery, on the engine block of the vehicle to be started is a good source.

Ensure that the S Style SSJL600 jump leads cannot come into contact with any moving parts of either engine. Start the engine of the boosting vehicle and run it at a fast idle speed for a few minuets. Now turn the ignition to start the engine of your vehicle, the S Style SSJL600 will pull power from the boosting battery to help your battery back to life. Check that your vehicle is running properly then carefully disconnect the SSJL600 and your on your way.

600 Amp.
3.0m length.
Jump lead with 10mm insulation.
Supplied in poly bag with euro slot.

£21.85 excl VAT